How to use Cummins Inline 7 Insite 8.3 to read fault codes?

Tested! Cummins Inline 7 is confirmed to work no issues with Insite software 8.3! successfully read trouble codes!

Software version: Insite 8.3.0.120

Cummins Inline 7 insite 8.3 get ready

Cummins insite 8.3 fault codes:

Fault codes are Cummins way of letting you know that your engine has a problem. Every sensor and circuit on your engine has a certain expected reading and voltage signal. These signals are monitored constantly by the Cummins ECM. If values rise above or below expected, the ECM will log a code.

If the error has occurred but is not happening at the time of diagnostics, it is known as an Inactive Fault. If the error is happening while you diagnose, it is known as an Active Fault.

All codes can be classified as either Active or Inactive, and their status can be determined by flash codes or through the Insite Electronic Service Tool.

the ECM will log a code.

If the error has occurred but is not happening at the time of diagnostics, it is known as an Inactive Fault. If the error is happening while you diagnose, it is known as an Active Fault.

All codes can be classified as either Active or Inactive, and their status can be determined by flash codes or through the Insite Electronic Service Tool.

What is new of Fault Codes in Cummins INSITE version 8:

– Fault Codes window displays an engine’s fault data

– Fault Codes include both engine faults and engine protection faults

– Each fault is represented by a Cummins fault code

• Indicates a specific malfunction or abnormal condition within the controller, subsystem, or

  engine

– Ability to link to Fault Information System for Troubleshooting Information

What’s new in Fault Codes Sorting in Cummins INSITE 8:

• Fault Codes can be sorted by either the column, or by right click for multiple column sorting
• The Fault Code data can be sorted by clicking on the column header for a single column sort
• The data will be sorted based on the selected column in ascending order. Click on the column header again to resort the data in descending order

Note: Sorting can only be used on the Fault Code, Status, Count, or Lamp columns

What’s new in Fault Codes Wrap Up in Cummins INSITE 8:

• Fault Codes window shows active and inactive Fault Codes
• Alternate click

– Link to Fault Information System for Troubleshooting information

– Clear Inactive Faults

• Links to Troubleshooting available in the Fault Information System