Recently I buy a newest BMW icom A2+B +C 2014.09 Engineer version. It work perfect.
This Engineer version can single program . I hear that before the 2014.03 version ,the BMW ICOM A2 software can not single Program.
I show the common question and solution about BMW ICOM A2+B+C diagnostic tool.
Q1: What is BMW ICOM password when loading?
A1: Input “bmw” in lowercase letters when the BMW ICOM software starts, when password 1 and password 2 appear, input “BMW” in capital letters for password 1, and enter nothing in password 2.
Q2: What computer System BMW ICOM Software require? Does it need to work on VMware?
A2: From Autonumen.com BMW ICOM software moveable hard disk need to work on VMware. But the ICOM software we supply in the website is internal hard disk compatible with Lenovo and Dell and no need to work on VMware, it requires to have Intel Chip, at least 4G memory, do not have to be 64bit, the internal hard disk is used to replace the initial computer hard disk.
Q3: What need to be set when the BMW ICOM software install?
A3: in the moveable hard disk you can check the user manual; but the internal hard disk software need not set, just insert the hard disk and start the computer it will work.
Q4: Which device works with BMW motorcycle, type: R1200GS 2004-201, R1200GS?2004-2013 and BMW R1200R? Can BMW ICOM do? If yes, does it need specific connector?
A4: Our hardware and software is compatible with your BMW motorcycle. But to make it work, it needs additional special interface-10pin cable for ICOM, we called it ICOM+D module, some customers use it and succeed, advice you have a try.
Leave a Reply