ISUZU N-Series Fuel Injector Flow Rate Programming by IDSS

When replacing the injector,it is necessary to register the ID code printed on the upper part of the injector with handheld tester in the engine ECU.So here i will show you guide on how to use IDSS software to do fuel injector flow rate programming after replacement.

Note:If the ID code of the newly installed injector is not properly registered,rough idling,abnormal noise,or other symptoms may occur.

Preparations:

Isuzu G-IDSS Export 2019 Diagnostic Software Free Download

Video:

Procedures:

Connect Nexiq interface to ISUZU diagnostic port,then run IDSS software.

After vehicle identification,select “Control Programming”–>”Engine Control Module Programming”–>”Inject Flow Rates”
ISUZU N-Series Fuel Injector Flow Rate Programming by IDSS-1 ISUZU N-Series Fuel Injector Flow Rate Programming by IDSS-2 ISUZU N-Series Fuel Injector Flow Rate Programming by IDSS-3 ISUZU N-Series Fuel Injector Flow Rate Programming by IDSS-4

Select which injectors you have replaced,then click “Next”
ISUZU N-Series Fuel Injector Flow Rate Programming by IDSS-5

Click each of the tabs below and enter injector Flow values.You must enter injector flow values for all injectors before pressing “Reprogram Injector Flow Rates”,or press Back to cancel
ISUZU N-Series Fuel Injector Flow Rate Programming by IDSS-6ISUZU N-Series Fuel Injector Flow Rate Programming by IDSS-7 ISUZU N-Series Fuel Injector Flow Rate Programming by IDSS-8

ISUZU N-Series Fuel Injector Flow Rate Programming by IDSS-9 ISUZU N-Series Fuel Injector Flow Rate Programming by IDSS-10
ISUZU N-Series Fuel Injector Flow Rate Programming by IDSS-11
ISUZU N-Series Fuel Injector Flow Rate Programming by IDSS-12

Click on a cell in the grid to the left to edit.

Characters can only be 0-9 and A-F.
ISUZU N-Series Fuel Injector Flow Rate Programming by IDSS-13

When finish injector 1-injector 4,click “Reprogram injector Flow Rates”
ISUZU N-Series Fuel Injector Flow Rate Programming by IDSS-14

Turn off the ignition and press “Next” to complete the programming process.
ISUZU N-Series Fuel Injector Flow Rate Programming by IDSS-15

Turn ON the ignition and press “Next” to complete the programming process.
ISUZU N-Series Fuel Injector Flow Rate Programming by IDSS-16

Programming Complete!
ISUZU N-Series Fuel Injector Flow Rate Programming by IDSS-17

Be the first to comment

Leave a Reply

Your email address will not be published.


*