How to Flash Steering Curve for ZF Steering by ODIS Engineering

This instruction will show you guide on how to do steering curve flashing for ZF steering on VW by ODIS Engineering.

During flash, pls note:

Fully charged battery and external

The Bluetooth connector is firmly connected to the OBD and uses a USB data cable

Do not move hardware and switch keys during refresh

Preparation:

Newest ODIS-E Engineering 12.1.1 & 9.0.4 Free Download

How to Install ODIS-Engineering 12.1.0 Diagnostic Software

Procedures:

Running ODIS Engineering, Select “0044- Power Steering System”–”Flash”

How to Flash Steering Curve for ZF Steering by ODIS Engineering-1

Select all files

How to Flash Steering Curve for ZF Steering by ODIS Engineering-2

Select “205 Curve” to test steering force.

How to Flash Steering Curve for ZF Steering by ODIS Engineering-3

And we found steering force didn’t change too much

After Steering Curve flashing, Select “Function configuration” –>”flash(engineering”, remove two ticks and save)

How to Flash Steering Curve for ZF Steering by ODIS Engineering-4

Turn off and turn on the ignition switch

How to Flash Steering Curve for ZF Steering by ODIS Engineering-5

Check the steering system

How to Flash Steering Curve for ZF Steering by ODIS Engineering-6

Now we flash Curve 205 to 239.

239 curve features is low speed, extra light, high speed,it is heavier.

How to Flash Steering Curve for ZF Steering by ODIS Engineering-7

Function is ready.

Be the first to comment

Leave a Reply

Your email address will not be published.


*